N14 Air Compressor Removal

N14 Air Compressor Removal FAQ

How do you disassemble a n14 engine?

Engine Disassembly (00-01) N14 Disconnect the Deutsch three pin connector that contains the vehicle key switch, fan clutch, and engine brake control wires from the three pin connector which is wired directly into the Deutsch nine pin connector on the sensor harness. Remove the actuator harness amp connector from the electronic control module (ECM).

How do you remove the oil pressure relief valve from n14?

Lubricating Oil System N14 Remove the oil pump cover. Remove and discard the cover gasket. Remove the 7/16-20 straight thread o-ring adapter from the oil pump cover. Remove the high oil pressure relief valve as follows: 1. Use the light-duty puller kit, Part No. 3375784, or its equivalent to remove the retainer plug (1). 2.

How do you test a n14 engine?

Engine Testing N14 Use an air tank (2). Install an air regulator (3) capable of maintaining 345 to 517 kPa [50 to 75 psi] air pressure at both minimum and maximum engine RPM. Install a steel tube or high temperature hose (1). Hose Temperature (Minimum): 235°C [500°F]. Connect the tube or hose (1) to the air compressor outlet.

What is the n14 n14 engine assembly?

Engine Assembly (00-02) N14 All overhead (valve and injector) adjustments must be made when the engine is cold (any stabilized coolant temperature at 60°C [140°F] or below). Each cylinder has three rocker levers: • The exhaust rocker lever (1).